Liebherr GTP 2356 Premium Operations Instructions download pdf (Page 4)

Power failure display

If nA appears in the display, this means that

the freezer temperature has risen too high

during the last few hours or days due to a

power failure.

If you press the ALARM button whilst the

display is reading nA, the highest tempera-

ture registered during the power failure will

be displayed. Check the quality of the food and its suitability for

consumption in case it has become too warm or even defrosted.

The highest temperature will appear for appox. 1 minute. After that,

the actual temperature in the freezer will re-appear. The display

can be switched o by pressing the ALARM button.

Audible warning signal

The audible warning device helps to protect the frozen food and

to save energy.

- It sounds when the lid has been left open for longer than about

60 seconds; (except model GT 1456)

- It sounds when it is not cold enough in the

freezer compartment. The temperature display

will also flash.

The audible warning device is switched o by

pressing the ALARM button.

Switching the appliance on and o

You are recommended to clean the appliance before switching it

on for the rst time (see Cleaning).

To switch the appliance on: Press the ON/OFF button until the

temperature display lights up.

- The two illuminated dashes of the digital tem-

perature display will light up until a temperature

of 0°C is reached.

- If the temperature is below 0°C, the digital

temperature display will show the temperature

inside the appliance.

To switch the appliance o: Press the ON / OFF button for ap-

prox. 3 seconds so that the temperature display goes out.

Setting the temperature

• To reduce the temperature: Press the

bottom button Down.

• To increase the temperature: Press the

top button Up.

- While you are entering the temperature, the

set temperature will flash on the display.

- You can change the settings in increments

of 1°C briefly pressing the button again. If the buttons are held

down the temperature setting will change faster.

- The electronic controls will switch over automatically about 5 sec-

onds after the last time you pressed the button, and the actual

temperature in the freezer will be displayed.

If F4 or F5 appears in the display, the appliance has a fault. It will

be kept at the right temperature by means of a safety circuit.

Consult your nearest customer service point.

➊ Temperature setting buttons

➋ On/O button

➌ Audible warning on/o button

➍ Child lock LED

➎ SuperFrost LED

➏ SuperFrost button

➐ Temperature display

Operating and control elements

Additional functions

In set-up mode you can set the child lock and adjust the brightness

of the display. The child lock is designed to protect the appliance

from being switched o accidentally.

Activating the child lock

Press for 5 seconds. Display =

Display =

1 2 3 4 5 6 7

Comments to this Manuals

No comments

Liebherr GTP 2356 Premium Operations Instructions Page 4

Comments to this Manuals

Related products and manuals for Freezers Liebherr GTP 2356 Premium