Liebherr CS1360 User's Guide Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
General Remarks
9
IV. Area Requirements
Verify the following:
Floors can support refrigerator’s weight plus approxi-
mately 1200 pounds (544 kg) of food weight. Not
all Liebherr products are designed for 1200 pounds
(544 kg) of food. Some units are smaller and total
weights may vary.
Finished kitchen floor height is level. Refrigerator must
be shimmed to the floor level, or levelled, to make
sure, air vents are not obstructed.
Remove anything attached to the rear or side walls
that can obstruct refrigerator opening.
Cutout dimensions are accurate.
Electrical outlet is in correct location.
Do not install this unit next to any other refrigerator or
freezer except another Liebherr model. Liebherr models
are designed to allow side by side installation. They are
equipped with a heating system to eliminate condensa-
tion when units are installed side by side. Installing this
unit next to any other refrigerator or freezer can cause
condensation or cause damage to the Liebherr unit.
To protect the refrigerator from possible
damage, allow the appliance to stand 1/2 to
1 hour in place before turning the electricity
on. This allows the refrigerant and system
lubrication to reach equilibrium.
Blocking For Safety
The anti-tip brackets must be installed to prevent the
unit from tipping after it is installed.
V. Safety Regulations
The appliance complies with UL250 and CAN/CSA
C22.2 No.63-93 and is designed to cool, freeze, store
food as well as make ice (if equipped). It is designed as a
household appliance.
The appliance is set to operate within specific ambient
temperature limits according to its climate rating. These
temperature limits should not be exceeded. The cor-
rect climate rating for your appliance is indicated on the
model plate.
This is explained as follows:
Climate
Rating
Set for Ambient Temperatures of
SN 50°F to 90°F (10°C to 32°C)
N 61°F to 90°F (16°C to 32°C)
ST 61°F to 101°F (16°C to 38°C)
T 61°F to 110°F (16°C to 43°C)
SN-ST
SN-T
50°F to 101°F (10°C to 38°C)
50°F to 110°F (10°C to 43°C)
Refrigerant circuits are tested for leaks.
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments