Liebherr CS2062 Use and Care Manual download pdf (Page 11)

operaTion

Temperature Display - Figure 8

Innormaloperation,thefollowingsettingswillbe

displayed:

• theaveragerefrigeratortemperature

• thewarmestfrozenfoodtemperature.

When starting up for the first time or when

the appliance is warm, dashes will appear

inthefreezertemperaturedisplay,untilthe

temperatureinthefreezercompartmentis

32°F(0°C).

Itwilltakebetweenthreeandeighthoursforthe

requiredtemperature,0°For38°F(-18°Cor3°C)to

be reached and displayed permanently in the display,

depending on the ambient conditions and the tempera-

ture setting.

The display will flash:

• ifyouchangethetemperatureor

• ifthetemperaturerisesbyseveraldegrees,indicating

coldloss,e.g.ifyouplacefresh,“warm”foodinthe

freezerorifyouremoveorrepackfrozenfood,the

temperature may rise for a short time due to warm air

flowingintothefreezer.

• If“F1” to “F5” appears in the display, the appliance

hasafault.Havethefaultnumberavailablewhenyou

contact the customer service department.

Audible Alarm Signal - Figure 8

Theaudiblealarmsignalhelpstoprotectfrozenfood

and to save energy.

The audible alarm signal is switched off by touching

the alarm icon.

Audible door alarm

This sounds when the door has been left open for

longerthanabout180seconds.Thesoundswitch-

off function is active as long as the door is left open.

The alarm automatically switches back to standby

when the door is shut.

Audible/visual temperature alarm

Italwayssoundsifthefreezertemperatureisnot

low enough. The temperature display and the alarm

LED

ﬂashes at the same time.

Thiscanbecausedby:

- warm,freshfoodbeingplacedinthefreezer;

- too much warm air from the outside entering

whenre-arrangingorremovingfrozenfood,

- a fault in the appliance.

The temperature display will continue to ﬂash until

thecauseofthealarmhasbeenrectied.Itwillthen

stop ﬂashing and light up continually. The audible

warning signal is now automatically reset.

Power Failure/Frost-Control

Display - Figure 8

IfthepowerfailureLED islit,thismeansthefreezer

temperature has risen too high during the last few hours

ordaysduetoapowerfailure.Thefreezertemperature

display flashes at the same time.

• IfyoutouchtheAlarm icon now, the highest tem-

perature registered during the power failure will be

displayed.

• Checkthequalityofthefoodincaseithasbecome

too warm or even defrosted.

• Thehighesttemperaturewillappearforapproximately

oneminute.Afterthat,theactualtemperatureinthe

freezerwillreappear.

 ThedisplaycanbeturnedoffbytouchingtheAlarm

icon again.

Supercool - Figure 8

TouchingtheSupercooliconswitchestherefrigerator

compartmenttomaximumcooling.Itisrecommended

particularly if you wish to cool large quantities of food,

drinks, freshly baked goods or meals rapidly.

• Turning on:TouchtheSupercoolicon briefly so the

LED

turns on. The refrigerator temperature will

drop to its lowest value.

IMPORTANT

The Supercool function uses slightly more energy.

After approximately six hours, however, the refrig-

erator switches back automatically to normal ener-

gy-saving operation. If required, the Supercooling

function can be turned off sooner.

• Turning off:TouchtheSupercooliconagainuntilthe

LED

turns off.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Comments to this Manuals

No comments

Liebherr CS2062 Use and Care Manual Page 11

Comments to this Manuals

Related products and manuals for Side-by-side fridge-freezers Liebherr CS2062