Liebherr FKv 4140 Operations Instructions download pdf (Page 4)

Temperature display

FKv 2640, 3640, 4140, 5440, GKvesf 4145, 5445

The temperature display is powered by a battery which is avail-

able from your specialist dealer.

Changing the battery

• Openthebatterycompartment

using a small screwdriver.

• Replacethebattery.

•Close the battery compart-

ment.

IfEr or HH appears in the dis-

play, the appliance has a fault.

Consult the customer service

department indicating the fault

number displayed.

Cooling

Thegridshelvescanbemovedtoaccommodatedierentheight

bottlesorpackages.

High-percentage alcohols

should be tightly sealed and

stored upright.

The ventilation slots on the

inside must not be covered!

Setting up

• Donotplacetheapplianceindirectsunlightornearcookers,

radiators and similar sources of heat.

• Theflooronwhichtheappliancestandsshouldbehorizontal

andlevel.Compensateforunevenfloorswiththeadjustablefeet.

•

Donotcoverventilationopeningsor

grille.

• StandardEN378specifiesthattheroominwhich

you install your appliance must have a volume

of 1 m

per 8 g of R 600a refrigerant used in

the appliance, so as to avoid the formation of

inflammable gas/air mixtures in the room where

theapplianceislocatedintheeventofaleakin

the refrigerant circuit. The quantity of refrigerant

used in your appliance is indicated on the type

plate on the inside of the appliance.

• Alwaysinstalltheappliancedirectlyagainstthewall.

Electrical connection

Onlyoperatetheappliancewithalternating current (AC).

The permissible voltage and frequency are indicated on the type

plate. The position of the type plate is shown in the section entitled

Description of the appliance.

Thesocketmustbeproperlyearthedandprotectedbyafuse.

The tripping current of the fuse must be between 10 A and 16 A.

Thesocketmustnotbesituatedbehindtheappli-

ance and must be easily accessible.

Donotconnecttheapplianceusinganexten-

sioncableorextensionsocket.

Donotusestand-aloneinverters(conversion

of direct current to alternating current/three-

phasecurrent)orenergy-savingplugs.Risk

ofdamagetotheelectroniccontrolsystem!

Switching the appliance on and o

Youarerecommendedtocleantheinterioroftheappliancebefore

switchingitonforthersttime(seeCleaning).

Switching the appliance on

Connecttheappliancetothemains-theapplianceisswitchedon.

Switching the appliance o

Pulloutthemainsplugorsetthetemperaturecontrolto0.

Important

When the temperature control is turned to "0", the refrig-

eration system is switched o, but the appliance is not

completely disconnected from the mains. Before cleaning,

always disconnect the appliance from the mains. Remove

the plug.

Setting the temperature

Set the temperature inside the appli-

ance using the temperature control.

The nearer the temperature control

is to the max. setting, the colder the

interior temperature.

Set the control between "0" and "max."

as required.

Appliance dimensions (mm)

A B C D E

FK / FKv 26.. 1250 600 610 650 1180

FK / FKv 36.. 1640 600 610 650 1180

FK / FKv / GKvesf 41.. 1800 600 610 650 1180

FK / FKv / GKvesf 54.. 1640 750 730 850 1410

1 2 3 4 5 6 7

Comments to this Manuals

No comments

Liebherr FKv 4140 Operations Instructions Page 4

Comments to this Manuals

Related products and manuals for Unknown Liebherr FKv 4140