Liebherr HWGW1803 Use and Care Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
14
T
roUbleshooTing
Customer Service
If none of the above possible causes apply, and you
can not rectify the fault yourself, contact the Liebherr
Service Center. Indicate the type (1) of appliance, ser-
vice number (2) and the appliance / serial number (3)
as shown on the model plate.
The position of the model plate is shown in the section
entitled Description of the Appliance.
Troubleshooting
Your appliance is designed and manufactured for a long life and reliable operation.
If a problem occurs during operation, check whether it is due to an operating error.
Please note that even during the warranty period, you may be responsible for certain repair costs.
Problem Possible cause and remedy
Appliance does not work, dis-
play is off.
- Is the appliance turned on?
- Is the power cord properly inserted in the outlet?
- Is the circuit breaker or fuse in working order?
Motor seems to
run too long.
- Is the ambient temperature too hot? See Safety Regulations.
- Has the appliance been opened too often or left open too long?
The temperature is
not cold enough.
- Is the temperature setting correct? See Setting the Temperature.
- Has an excessive amount of wine been placed in the appliance?
- Does a separately installed thermometer show the correct reading?
- Is the ventilation system working properly?
- Is the appliance set up too close to a heat source?
The fans inside the appliance
are running even though the fan
function has been deactivated
and the compressor (refrigera-
tion unit) is idle.
- This is a normal operating state depending on the set interior temperature and
ambient temperature at the place of installation.
F1 appears in the display. - A fault has occurred in the appliance. Contact the Liebherr Service Center.
When inserting the mains plug,
the refrigeration unit does not
switch on, but a value is shown
in the temperature display.
- Demo mode is activated. Contact the Liebherr Service Center.
Page view 13
1 2 ... 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments