Liebherr ZKes 453 Humidor User Manual download pdf (Page 6)

Switching on for the ﬁrst time

Before switching on the appliance, ﬁll the water tank

with 1 litre of distilled water.

Use distilled water only!

Fold down the front ﬂap completely and if necessary

slide it into the appliance as far as it will go. Lift the

water tank slightly, remove and ﬁll with water.

Replace the water tank, sliding it in as far as it will go.

Pull out the front ﬂap completely and fold upwards at

a 90° angle.

To switch on

Press the On/Off button. The display will ﬂash.

The appliance will take 24 hours to reach the correct

level for storing cigars (temperature, humidity).

The factory setting is +18°C and 70% humidity.

To switch off

Press the On/Off button for 3 seconds until the display goes dark.

Setting the temperature

To reduce the temperature

Press the Down button.

To increase the temperature

Press the Up button.

- While you are entering the tempera-

ture, the set temperature will ﬂash on

the display.

- The electronic controls will switch over automatically about 5 seconds after the last

time you pressed the button, and the interior temperature will be displayed. The tem-

perature can be set between +16°C and +20°C.

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

No comments

Liebherr ZKes 453 Humidor User Manual Page 6