Liebherr WTUes 1653 Operations Instructions download pdf (Page 6)

Switching the appliance on and off

You are recommended to clean the appliance before switching it on for the ﬁrst time

(see "Cleaning"). Connect the appliance to the mains - the appliance is switched on.

The alarm will sound when the appliance is switched on for the ﬁrst time and when the

appliance is warm. Press the "Alarm" button to switch it off. The temperature display

will also ﬂash.

• To switch the appliance off: Keep the "ON / OFF" button pressed

for 3 sec. so that the temperature display goes out.

• To switch the appliance on: Press the "ON / OFF" button until the

Display lights up.

Setting the temperature

The temperature of both compartments can be set separately.

To reduce the temperature: Press the DOWN button;

- on the left for the upper compartment, on the right for the lower compartment.

To increase the temperature: Press the UP button.

- While you are entering the temperature, the set

temperature will ﬂash on the display.

- You can change the settings in increments of 1°C

brieﬂy pressing the button again.

- The electronic controls will switch over automatically about 5 seconds after the

last time you pressed the button, and the actual temperature will be displayed.

If "F0" or "F1" appears in the display, the appliance has a fault. Consult your nearest

customer service point, quoting the type of appliance, index and appliance number.

Fan button

Should you wish to use the wine cooler to store wine for long periods of

time, activate the "Ventilation" button. The light in the button comes on.

Thereby a climate which corresponds to that of a wine cellar is achieved

inside the wine cooler. Corks are prevented from drying out due to an

increased level of humidity.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Liebherr WTUes 1653 Operations Instructions Page 6