Liebherr HF861 Use and Care Manual download pdf (Page 11)

NOTICE

Incorrect cleaning damages the appliance.

Do not use concentrated cleaning agents.

Do not use steel wool or sponges that scour or scratch.

Do not use caustic or abrasive cleaning materials or

those containing sand, chloride, or acids.

Do not use chemical solvents.

Do not damage or remove the rating plate on the inside

of the appliance. It is vital for the customer service

department.

Do not pull off, kink or damage any cables or other

components.

Do not let cleaning water get into the drain gutter, the

ventilation grille and electrical parts.

Use soft cleaning cloths and a multi-purpose cleaning

agent with a neutral pH value.

Only use food-compatible cleaning and care agents

inside the appliance.

Empty the appliance.

Disconnect the power plug.

Clean the ventilation grilles regularly.

Dust deposits increase energy consumption.

Clean the plastic surfaces, outside and inside, by

hand using lukewarm water and a little dish washing

liquid.

Clean fittings by hand using lukewarm water and a

little dish washing liquid.

Clean the telescopic rails with a damp cloth only. The

grease in the tracks is for lubrication purposes and

should not be removed.

After cleaning:

Wipe the appliance and accessories dry.

Connect the appliance and switch it on again.

Switch on SuperFrost (see 5.9) .

When the temperature is sufficiently cold:

put the food back in the appliance.

6.4 Cleaning the IceMaker

The IceMaker drawer must be emptied and pushed in.

Activate setting mode: press and hold the SuperFrost

button

Fig. 2 (5)

for approximately 5 s.

S is shown on the display.

The Menu symbol

Fig. 2 (9)

lights up.

Using the Up button

Fig. 2 (3)

/ Down button

Fig. 2 (4)

select I.

To confirm: press the SuperFrost button

Fig. 2 (5)

Using the Up button

Fig. 2 (3)

/ Down button

Fig. 2 (4)

, select Ic.

To confirm: press the SuperFrost button

Fig. 2 (5)

The IceMaker moves into cleaning position and shuts

off.

Deactivate setting mode: press the On/Off button

Fig. 2 (1)

-or-

Wait 2 min.

The temperature is again displayed on the temperature

display.

Take out the drawer.

Clean the ice compartment and drawer with warm

water. If necessary, use a mild dishwashing liquid. Then

rinse.

Slide the drawer back in.

Leave the IceMaker switched off in this position.

-or-

NOTICE

Residual dishwashing liquid in the ice tray and drawer.

Nausea or irritation of the mucous membrane.

Eliminate any residual dishwashing liquid: Throw away

the first three batches of ice cubes.

Switching on the IceMaker (see 5.16) .

6.5 Customer service

First check whether you can remedy the fault yourself

(see Troubleshooting). If this is not the case, please

contact a qualified service provider.

WARNING

Risk of injury from repairs by non-professionals.

Repairs and work on the appliance and the power

supply cable not described in the Manual (see Mainte-

nance) should only be carried out by a qualified service

provider.

Read the appliance

designation

Fig. 10 (1)

, service no.

Fig. 10 (2)

and serial

no.

Fig. 10 (3)

from

the rating plate. The

rating plate is located

inside the appliance

on the left-hand side.

Fig. 10

Notify a qualified service provider, specifying the fault,

appliance designation

Fig. 10 (1)

, service no.

Fig. 10 (2)

and serial

Fig. 10 (3)

no.

This will help us to provide you with a faster and more

accurate service.

Keep the appliance closed until the Customer Service

engineer arrives.

The food will stay cool longer.

Disconnect the power plug (do not pull on the power

cord to do this) or switch off the fuse.

6.6 Appliance Information

Make a note of this information when the appliance is

installed:

Type Designation: _____________________

Maintenance

* Depending on model and options 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Liebherr HF861 Use and Care Manual Page 11

Comments to this Manuals

Related products and manuals for Fridge-freezers Liebherr HF861