Liebherr HF861 Use and Care Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 18
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
Problem Possible Cause Correction
(the motor)
switches on.
placed in the appliance or the door
has been left open for a while.
The ambient temperature is too high.
u
Solution: (see 1.3)
A low hum
The sound occurs as a result of fan
air flow.
u
The sound is normal.
Vibration noise
The appliance is not standing firmly
on the floor. As a result, objects and
adjoining units are set into vibration
by the running refrigeration unit.
u
Check the installation and realign the appliance if
necessary.
u
Move bottles and containers apart.
Flow noise on
the soft stop
mechanism.
The sound is caused by the soft stop
mechanism.
u
The sound is normal.
The temperature
display indi-
cates: F0 to F9.
There is a fault.
u
Contact the customer service department (see Main-
tenance).
The temperature
display shows a
flashing power
failure symbol
. The
warmest temper-
ature reached
during the power
failure is
displayed in the
temperature
display.
The freezer temperature rose too
high during the last hours or days
due to power failure or power inter-
ruption. When the power interruption
is over, the appliance will continue to
operate at the last temperature
setting.
u
To delete the display of the warmest temperature:
Press the Alarm button
Fig. 2 (7)
.
u
Check the quality of the food. Do not consume
spoiled food. Do not re-freeze defrosted food.
DEMO lights up
in the tempera-
ture display.
The demo mode is activated.
u
Contact the customer service department (see Main-
tenance).
The outside
surfaces of the
appliance are
hot*.
The heat of the refrigerant circuit is
used to prevent condensate from
forming.
u
This is normal.
The IceMaker
cannot be
switched on.
The appliance and therefore the
IceMaker are not connected.
u
Connect the appliance (see Start-up).
The IceMaker is
not making ice
cubes.
The IceMaker is not switched on.
u
Switch the IceMaker on.
The drawer of the IceMaker is not
properly closed.
u
Close the drawer properly.
The water connection is not open.
u
Open the water connection.
The water supply to the IceMaker
was interrupted.
u
Check the connection to the water supply (see the
Assembly Instructions, Connecting the Water
Supply).
u
Check the pipes and hoses (see the Assembly
Instructions, Connecting the Water Supply).
Troubleshooting.
* Depending on model and options 13
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments