Liebherr HCB2081 Installation Manual

Installation InstructionsFor Fully Integrated NoFrost Combined Refrigerator-FreezersHC 2080/2081HCB 2080/20817084 851-00

Safety Instructions and Warnings • Donotinstallthewaterconnectionwhilethecom-bined refrigerator-freezer is connected to an electrical outlet.

11IcemakerFigure 17Figure 189. Open the shut-off valve for the water supply and check the entire water system for leaks.Connection to the Water Supply

Fastening the Appliance in the Recess - Figure 20Fasten the appliance in the recess through the pre-mounted supports at left and right on the applianc

Before Mounting the Door Panels - Figure 23Remove cover 1 and unscrew the upper and lower attachment bracket 2 of the refrigerator door. These bracket

Mounting the Attachment Brackets onto the Door Panels - Figure 25Mark a line with a distance of 41" and 4-1/4" from the bottom of the refrig

2. Open the refrigerator door and hang the panel on the top adjusting bolts (Figure 27).3. Screw on the hex nuts to the adjusting bolts and fin-ger ti

Figure 338. Turn the adjusting bolts (bottom refrigerator door) until they make contact with the attachment bracket (Figure 30).Figure 30Figure 319. S

Mounting the Ventilation Grille - Figure 35, 361. Pull out the bottom freezer drawer.2. Remove the blue protection film from the dust filter provided

For Service in the U.S.Liebherr Service CenterToll Free: 1-866-LIEBHERor1-866-543-2437Email: [email protected] Solutions, I

2R600a Refrigerant WARNING! The refrigerant contained within the appliance R600a is environmentally friendly, but flammable. Leaking refrigerant can

3Disposal of CartonThe packaging is designed to protect the appliance and individual components during moving and is made of recyclable materials. W

Unit Dimensions - Figure 1Unit Venting - Figure 3HC 2080/2081 appliances do not require any ventilation openings in the cabinet. The required airflow

Cabinet Opening Dimensions - Figure 4Figure 4IMPORTANTFor 24" cabinets, the water line opening must be in the location as shown. With cabinets de

Panel Dimensions - Inset Installation Style - Figure 5Figure 5The panels should be at least 5/8 inch (16 mm) thick to allow the connecting rails to be

Panel Dimensions - Frameless Installation Style - Figure 6The gap between panels with frameless installation style is 1/4" (6 mm). The panels sho

Figure 8Wall plateWallSecure the appliance in place so it does not tip forward when the fully stocked door is opened. The anti tipping bracket is prov

Mounting the Anti Tipping Device in Cabinets deeper than 24" - Figure 10 - 11To ensure the compressor mounting plate reaches the anti tipping bra