11
Notes on energy saving
• Avoid opening the door unnecessarily for long periods of time.
• Allow hot food to cool to room temperature before storing it in the
appliance.
• If an ice layer forms, defrost the appliance. This will improve the
cold transfer and reduce energy consumption.
Switching the appliance on and o
You are recommended to clean the appliance before switching it
on for the rst time (see "Cleaning").
Turn the temperature control T clockwise from "0" to "1". The ap-
pliance is now switched on and the interior light comes on. The
appliance is switched o at the "0" setting (g. A / B).
Switch W (depending on options)
Turn the rocker switch W on the temperature control housing for
operation at low room temperatures of 18°C or below. The control
lamp in the switch comes on. This ensures that the necessary low
temperature inside the freezer compartment is achieved.
It is not necessary to turn on the rocker switch at normal room
temperatures (above 18°C).
g. A g. B
Setting up
• Standard EN 378 specifies that the room in which you install
your appliance must have a volume of 1 m
3
per 8 g of R 600a
refrigerant used in the appliance, so as to avoid the formation of
inflammable gas/air mixtures in the room where the appliance
is located in the event of a leak in the refrigerant circuit. The
quantity of refrigerant used in your appliance is indicated on the
type plate on the inside of the appliance.
• Do not connect the appliance to the supply with other equipment
using an extension cable - risk of overheating.
Connecting to the mains
Power supply (a.c.) and voltage at the operating point must comply
with the details on the type plate, which is located in the refrigerator
compartment on the left-hand side. The socket must be fused with
a 10 A fuse or higher, it must be away from the rear of the appliance
and must be easily accessible.
Connect the appliance with a properly earthed fused plug
and socket only.
The wires in the mains lead are coloured in accordance with the
following code: green/yellow = earth, blue = neutral, brown = live.
Warning! This appliance must be earthed.
Setting the temperature
Turn the temperature control T to set the desired temperature.
Setting "1" = lowest cooling setting, warm
Setting "7" = highest cooling setting, cold
When storing pre-frozen food in the freezer compartment, we recom-
mend a temperature setting of between 4 and 7, in order to achieve
temperatures of -18°C or lower inside the compartment.
Interior light
Bulb data: 15 W (never use a bulb rated at more than 15 W). The
voltage should agree with the details on the type plate.
Socket: E 14.
Replacing the bulb:
Pull out the mains plug or remove/unscrew the fuse.
Version as in g. A
Reach behind the cover, unscrew the bulb and replace.
Version as in g. B
Lift the cover ➋ in the direction of the arrow and remove. Replace
the bulb and click the cover back into place.
Changing shelf arrangement
You can re-arrange the storage shelves
as required. Lift up shelves at the front,
pull them out halfway and remove by tilting
upwards or downwards.
When inserting a shelf, the guard bar at the
back must be facing upwards, otherwise
food may freeze to the rear wall.
Repositioning the door racks
Lift door rack vertically, lift out to the front
and re-insert at a dierent height, following
these steps in the reverse order.
By shifting the bottle holder F you can
protect the bottles from falling over when
opening or closing the door.
GB
(18 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals