Liebherr BF1051 User Manual download pdf (Page 24)

BFI/BF1051 / BGEN/es 2956

A delight in freshness

Figure 21: Secure the refrigerator in place so it

does not tip forward when the fully stocked door

is opened.

2. Measure the distance from the floor to the

upper edge of the unit.

3. Locate and mark two wall studs (1) against the

wall where the refrigerator will be located. The

space between the unit top and the bottom

of the brackets must not be more than

1/4" (0.635 cm).

4. Make sure the screws (2) extend a minimum of

1" (2.54 cm) into each of the wall studs.

5. Make sure the anti-tip brackets (3) extend at

least 3" (7.62 cm) over the unit and are

securely in place.

BLOCKING

FOR SAFETY

IMPORTANT

The anti-tip brackets can be installed in either

direction or closer together. Always position

the anti-tip brackets as wide apart as

possible, but make sure they are anchored to

two studs.

6. Using the adjustable roller base, raise the unit

until it makes contact with the brackets. Make

sure the front levelers are firmly on the floor to

prevent appliance from tipping forward.

IMPORTANT

If your unit is positioned in between the wall

studs, a board can be secured to the wall.

Make sure the board is secured to the studs

with screws that will penetrate into the studs a

minimum of 1" (2.54 cm). The board should

be a minimum of 1" x 6" (2.54 cm x 15.24 cm)

and long enough to secure both ends to the

wall studs.

Figure 21

min 3"

BGEN_7082248_0929_Install_3Lang.qxd 10/21/2004 7:56 AM Page 22

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 109 110

No comments

Liebherr BF1051 User Manual Page 24