19
GB
Alarm messages
1. LED flashes
If
appears in the display, the appliance has a fault.
Consultyournearestcustomerservicepoint.
2. LED
flashes and appears in the display
The power failure alarm battery is supplying too low a voltage
or is defective.
Consultyournearestcustomerservicepoint.
3. LED
flashes, the display reads HI or LO
The interior is too warm (HI) or too cold (LO).
The audible warning signal sounds.
4. HACCP flashes - the current interior temperature,
and
are displayed alternately
There has been a power cut of some length or the interior was
too warm or too cold during a certain period of time.
Up to three alarm events can be stored and called up.
Alarm test
Thistestchecksthefunctionoftheinternalandanyexternal
connected alarm device.
The appliance does not stop its refrigerating function during
this test.
Activating the test
Press
+ for 5 seconds.
• Thedisplaywillchangetoatemperaturevalueof0.2°Cbelow
the set upper alarm limit.
• Thetemperaturevaluewillnowriseby0.1°Cevery2seconds.
• When the upper alarm limit is reached,
will appear in the
display. An external alarm unit connected to the floating alarm
output will now be activated.
• Thetemperaturevaluewillcontinuetoriseupto0.2°Cabove
the upper alarm limit.
• Thesameprocesswilltakeplaceautomaticallyforthelower
alarm limit.
will appear in the display.
TheLED
will be lit during the test.
Theelectroniccontrolsystemwillautomaticallyswitchbackto
normal operating mode.
Cancelling the test prematurely
Press
for 5 seconds.
Audible warning signal settings
The audible warning signal will be muted for the current alarm
after the button
has been pressed.
Complete the following stepsifyouwantthe audible warning
signal to reactivate automatically.
Press
for5seconds.Display=
Display=
Display=
Display=
Display=
Display=
Display=
Display=
Display=
Automatic reactivation of the audible warning signal is now active.
The time before the audible warning signal sounds again must be set.
Display=
Display= Time in minutes after which the audible
warning signal will sound again after the
button
has been pressed. Setting
range=1-120minutes.
Use buttons
and to select the desired setting.
Display=
Press for 5 seconds.
Theelectroniccontrolsystemwillswitchbacktonormaloperat-
ing mode.
Comments to this Manuals